MKS T3PIA, Instruction Manual, Page: 56 / 70

Appendix A: Product Specifications Troubleshooting
48
Performance Specifications
Control Range
Pressure Control
Position Control
resolution
0.5 to 100% of sensor range
0
°
to 50
°
for 100 mm
0
°
to 65
°
for 160 mm
0
°
to 68
°
for 200 mm
0
°
to 75
°
for 250 and 320 mm
0.0058° for all valve sizes
Controller Repeatability ±0.1% of FS
Heater Specifications
Heating Method Cartridge Heater
Heating Voltage 100 or 240 VAC; selected in model number
Temperature Control Electronic temperature controller on heater line cord.
LED display indicates heater status. When on, the heater is
+/- 20 degrees of the setpoint temperature.
Heater Temperature Set at factory based on model code.
Over Temperature Protection Manual reset thermal switch on valve.
Mains Protection This device is protected by an individual fuse located in the
power plug (100 to 120 VAC devices only).
10 Amp 250 VAC for flange size 100-320 mm
MKS assumes no responsibility if the supplied plug is
removed.
For heater operation using 200 to 240 VAC, the heater power cable is not terminated.
It is the responsibility of the end user to properly terminate and fuse.
Wire Assignment Black: Line (120 VAC or 220 VAC)
White: Neutral (120 VAC) or Line (220 VAC)
Green: Ground
Suggested Fuse Ratings for
200 to 240 VAC Use Flange Size: 100 mm (4") 10 Amp 250 VAC
160 mm (6") 10 Amp 250 VAC
200 mm (8") 10 Amp 250 VAC
250 mm (10") 5 Amp 250 VAC
320 mm (12") 5 Amp 250 VAC
Use a VDE approved fuse or equivalent.
Due to continuing research and development activities, these product specifications are subject to change without notice.