MKS T3PIA, Instruction Manual, Page: 55 / 70

Troubleshooting Appendix A: Product Specifications
47
Appendix A: Product Specifications
Digital Communication Specifications
Connector 25-pin, type ‘D’, female
Data Bits, Parity, Stop Bits Switch 8 Data bits, no parity, 1 stop bit, 19,200 baud rate
Maximum Cable Length 50 ft.
Response Time < 20 msec (typical)
Electrical Specifications
CE Compliance
Electromagnetic Compatibility
1
Product Safety Requirements
Machinery Directive
Low-Voltage Requirements
Installation Category
Pollution Degree
Meets Directive 2004/108/EEC
Meets Directive 92/59/EEC
Meets Directive 89/392/EEC
Meets Directive 73/23/EEC
II, according to EN 61010-1
2, according to IEC 664
Connectors
Auxiliary
Analog Sensors
Power
25-Pin Female Type “D”
15-Pin Female Type “D”
9-Pin Male Type “D”
Power Requirements 24.0 VDC @ 3 Amp (2 Amps for the motor drive and up to
750 mAmps for the pressure sensor gauges)
Signal Inputs
Pressure
Analog Set Point
TTL
0 to +10 VDC
0 to +10 VDC
Valve open and valve close, Pressure/Position, Learn Valve,
Learn Conductance, Interlock, Remote Zero
Signal Output
Analog
TTL
Open Collectors
Pressure out, position out
Valve Open, Close status
Alarms; 2, rated for 30 VDC @ 250 mA maximum (levels and
assignment to position, pressure, set point via software)
Environmental Specifications
Ambient Operating Temperature Range 20° to 40° C
Operating Humidity Range 0 to 95% RH, non-condensing
Storage Temperature Range -20° to 80° C
1
An overall metal braided shielded cable, properly grounded at both ends, is required during use.