Adjustment purpose
[Liquid Crystal Panel
Driving Adjustment Circuit]
4. White Balance (50%)
Symptom when
incorrectly adjusted
Measuring
instrument
Test point
EXT trigger
Measurement
range
Input signal
Input terminal
The best white balance of picture.(50%White)
Monochrome picture has a color tint.
---
---
---
---
SVGA signal
(White 50%, No. 12)
COMPUTER IN terminal
* Make this adjustment only when a monochrome picture has color tints
remarkably.
* Enter the adjustment commands and adjustment values of the decimal number in
small alphanumeric letters.
* Carry out this adjustment after running the product for 2 minutes or more
supplying the specified test signal to it.
1. Connect this PROJECTOR to a personal computer (with Microsoft
Windows
95 Operating System). (Refer to the figure on P.1)
2. Start Microsoft
Windows
95 in the personal computer.
3. Start the communication program [Hyper Terminal] in Microsoft
Windows
95
to open the window. (For setting, refer to Hyper Terminal setting on P.2)
4. Set the following items on the picture menu.
CONTRAST . . . . . . . . . . . . . . .0
BRIGHTNESS . . . . . . . . . . . . .0
COLOR TEMP . . . . .1 (standard)
5. Project a picture on the screen.
6. Supply an SVGA signal (White 50%, No. 12).
7. Enter the adjustment commands of red, green or blue so that the color tints at
the screen center disappear.
Increase the adjustment value to deepen the color adjusted, and decrease it to
lighten the color.
Optimum adjustment range (reference) x=0.277+0.010 / -0.015
y=0.329±0.010
8. Write the changed value onto the EEPROM by entering the command for
writing after the adjustment.
Red (Red Gamma Bright)
a. Enter the adjustment command [00~801
] to the Hyper Terminal window to
adjust the red to be optimum. Enter [-30]~[+10] to
for optimum red.
(*1) When the sent command is displayed, sending is accomplished correctly.
The current value is confirmed by sending the command without entering
any value to
.
b. Enter the command for writing [00~81] to the Hyper Terminal window to write
the changed value onto the EEPROM. (*1)
Green (Green Gamma Bright)
c. Enter the adjustment command [00~802
] to the Hyper Terminal window to
adjust the green to be optimum. Enter [-20]~[+05] to
for optimum green.
(*1)
d. Enter the command for writing [00~81] to the Hyper Terminal window to write
the changed value onto the EEPROM. (*1)
Blue (Blue Gamma Bright)
e. Enter the adjustment command [00~803
] to the Hyper Terminal window to
adjust the blue to be optimum. Enter [-50]~[+50] to
for optimum blue. (*1)
f. Enter the command for writing [00~81] to the Hyper Terminal window to write
the changed value onto the EEPROM. (*1)
6
Summary of Contents for S290U
Page 83: ...16 ...
Page 180: ...113 SYMBOL NO ADDRESS X7A1 A 3 PCB MAIN COMPONENT SIDE ...
Page 188: ...121 ...
