Mircom FX-3500RCU, Installation And Operation Manual

Page: 21 / 103

21
Table 2 Main Board Connectors and Jumpers
Connector/
Jumper Description
P2 To Power Supply
P3 To Power Supply
P4 Ribbon Cable connects to P4 of MAM-3500
P5 To PC Configurator
P7 Factory Use Only
P8 To PR-300
P9 To Printer
P10 To ALC-636 Loop Adder
P11 Factory Use Only
P13 USB Port
P14 Future Use
JW1 Must be closed (on) - Allows Configuration Connection. The default setting is closed (on).
JW2 Must be closed (on) - Annunciator End of Line. The default setting is closed (on).
JW5 Normally open (off). Place jumper here and power down (AC and batteries) and power
back to restore Master Password. After reset, remove jumper and leave normally open.
The default setting is open (off).
JW6 Normally open (off) to BLOCK remote configuration via modem. Place jumper here to
ALLOW for remote configuration. When jumper is set panel will indicate a trouble. The
default setting is open (off).
JW7 On the Main Fire Alarm Module, this jumper must be removed if a PR-300 Polarity
Reversal and City Tie Module is installed. The default setting is closed (on).
JW10 Must be in the 1-2 Position (Bottom 2 Pins) - Allows PC Connection through serial port.
The default setting is the 1-2 position.
JW11 Place in the 1-2 Position (Bottom 2 Pins) for Serial Port or Place in the 2-3 Position (Top 2
Pins) for Keltron Dialer. The default setting is the 1-2 position.
JW12 Close pins 2 and 3 to send the debug trace to the printer. Close pins 1 and 2 to send
events to the printer. The printer is supervised when the pins are in position 2 and 3. The
default setting is the 1-2 position.
Table 3 Core Board Connectors and Jumpers (Plug-in Board in Center of Main Board)
Connector/
Jumper Description
P5 Micro-B USB port: Connect to a computer for configuration.
JW4 Factory set closed (on). Leave as is.
JW5 Factory set open (off). Leave as is.
Attention: ADVANCED INSTALLER NOTE
Closing JW5 and JW6 on the main board at start-up will revert the panel
to the default configuration.
!