MIRAART TRAUMSCHWINGER Babyschwinger, Manual

Page: 15 / 32

-
15
-
5.6 Placing the wood wedge over
the stainless steel inlay
5.7 attach the second noble steel
inlay
Place now the wooden wedge,
which is inserted already with the
imported steel pin with smooth sides
on the already mounted stainless
steel inlay. Place the wooden wedge
so, that the protruding steel pin in
the slot of the stainless steel inlay
must perform.
Take the second stainless steel
inlay in your hand. Grasp the
stainless steel inlay so, that
with the label marked side facing
upward. Run the stainless steel inlay
on the threaded rods and place it on
the stainless steel bushings. Make
sure that the steel pin in wooden
wedge also performed in this second
slot of the stainless steel inlay. It
must be Ensure!!
SAFETY NOTICE
It´s imperative that with colored stickers marked sides of the wooden panel
and the stainless steel inlays lie on each other. This provides that only the
rounded edge of the stainless steel inlays contacted with the supporting
ropes. Failure to comply these installation instructions may increase wear of
the supporting ropes.