Page 14
EZ Mop 360° User Manual
1. Fit the brush or pad driver (with abrasive pad) that is suitable for the surface and the work to be
performed.
2. Fit the squeegee and make sure that it is securely fastened, connected to the suction hose and that the
blades are not excessively worn.
3. Fill the solution tank with a mixture of clean water and a suitable amount of non-foaming detergent (using
the graduated container provided).
4. Check the battery charge level and charge if necessary.
NOTE:
To avoid hazards, we recommend that you become familiar with the machine movements by
experimenting on a large surface that is free from obstacles.
To obtain the best results in terms of cleanliness and the service life of the appliance, you should follow a
few simple, but important procedures:
• Identify the work area and remove all possible obstacles that may get in the way. If the surface is very
large, work in contiguous and parallel rectangular areas.
• Choose a straight work trajectory and start working from the area furthest away to avoid going over areas
that have already been cleaned.
5.2 RECHARGING THE BATTERY
1. Connect the battery extension cable 1 to
the plug of the battery charger 2.
2. Plug the battery charger into a mains
socket and charge the battery as long
as the red LED on the battery charger 2
remains on.
3. When the green LED on the battery charger
2 lights up it means that it is fully charged.
4. Disconnect the plug of the battery charger
2 from the battery extension cable 1.
Summary of Contents for EZ Mop 360 degrees
Page 1: ...EZ Mop 360 User Manual ...
