Page 17
EZ Mop 360° User Manual
ASSEMBLY PROCEDURE:
1. Position the squeegee support 1 so that it is facing upwards A
2. Insert the squeegee 2 onto the holes X in the support 1.
3. Tighten the knobs 3 securely to fasten the squeegee 2 to the support 1.
4. Insert the suction hose 4 into the sleeve 5.
REMOVAL PROCEDURE:
1. Position the squeegee support 1 so that it is facing upwards A
2. Disconnect the suction hose 4 from the sleeve 5.
3. Loosen the knobs 3 that fasten the squeegee 2 to the support 1.
4. Remove the squeegee 2.
5.7 REPLACING THE SQUEEGEE BLADES
1. Remove the squeegee A from its support (see previous section).
2. Completely unscrew the rear knobs 1 and remove the pins 2.
3. Remove the squeegee blade 4-6 clamping strips 3-7.
4. Remove the rubber blades 4-6 from the body 5 of the squeegee by pulling from one end.
5. To replace the rubber blade, follow the same procedure in reverse starting from the rear blade 6.
6. Fit the rectangular holes on the blades into the seats on the body 5 of the squeegee.
7. Replace the blades 4-6 and the clamping strips 3-7
8. Insert the pins 2 and fasten the whole unit using the knobs 1.
5.6 FITTING AND REMOVING THE SQUEEGEE
CAUTION
The front rubber blade is different from the rear blade as it has notches through which water
can pass.
The clamping strips are identical.
Summary of Contents for EZ Mop 360 degrees
Page 1: ...EZ Mop 360 User Manual ...
