MiniMax FORMULA T1, Manual

Page: 49 / 57

REGOLAZIONI
7.14
T1
BF-NGB71
7-9 7-9
7-9 7-9
7-9 HOOD-FENCE ADJUSTING FOR PROFILING WITH NOT ALIGNED HOOD-FENCE ADJUSTING FOR PROFILING WITH NOT ALIGNED
HOOD-FENCE ADJUSTING FOR PROFILING WITH NOT ALIGNED HOOD-FENCE ADJUSTING FOR PROFILING WITH NOT ALIGNED
HOOD-FENCE ADJUSTING FOR PROFILING WITH NOT ALIGNED
FENCE HAL
FENCE HAL
FENCE HAL FENCE HAL
FENCE HALVES VES
VES VES
VES
Loosen handles (L and H fig.7.14) and move the entire hood-fence to the position required for the
removal depth: fence halves (M) and (P) shall be aligned with the minimal diameter of the cutter, then
tighten the handles.
Both fence halves shall be as near the tool as possible: adjust by means of the 2 knobs (F fig.7.15)
behind the fence halves.
Micrometric adjustment of the removal depth: adjust fence half (P) as follows:
- Hold handle (L fig.7.14) clamped
- Loosen handle (H fig.7.14)
- Turn knob (R fig.7.15) to find the right position: read out the measure on rule (T fig.7.15)
- Tighten handle (H fig.7.14)
Micrometric adjustment of fence half (M):
-
Hold handle (H fig.7.14) clamped
- Loosen handle (L fig.7.14)
- Turn knob (R fig.7.15) and with a small rod check the alignement of the fence half with the cutter.
- Tighten handle (L fig.7.14).
NOTE: NOTE:
NOTE: NOTE: NOTE:
In case of very long pieces use roller tables or
table extensions.
After any adjusting always close the top cover of the hood - fence unit.