Minebea MPC-201-25, Instruction Manual, Page: 68 / 124

50
9-2-4.
Alarm Output Condition Settings
Use either monitoring zone or integral pressure to perform alarm monitoring.
If the monitoring conditions are met, an alarm signal is output.
(1) Alarm monitoring using zone
Setting Description
Monitoring
zone Monitoring 1
Monitoring 2
Monitoring 3 Type Area
*1
Outputs an alarm if the pressure falls
outside the upper or lower limits set
within the monitoring period.
Peak Outputs an alarm if the waveform data
peak falls outside the upper or lower
limits set within the monitoring period.
Point
*2
Outputs an alarm if the pressure falls
outside the upper or lower limits after
the monitoring period.
Time to
peak
*3
Outputs an alarm if the time taken to
reach the peak within the measuring
period is outside the preset time.
Pressure Sets upper and lower values.
Time Sets monitoring start and finish times.
*1 [Area] can be set for Monitoring 1 and Monitoring 3.
*2 [Point] cannot be set for more than one monitoring system.
*3 [Time to peak] cannot be set for more than one monitoring system.