Mindray BeneFusion uVP, Instructions For Use Manual

Page: 20 / 62

4 - 2
Otherwise, the accuracy of the infusion and the performance of the pump
may be adversely affected.
•
To ensure the accuracy of rate and alarm detection, the infusion set should be
calibrated in this pump before first use.
•
When using the pump for blood transfusion, only use disposables dedicated
and labelled for transfusion.
•
Single use accessories are not designed to be reused. Reuse may cause a risk
of contamination and affect the measurement accuracy.
NOTE
•
Take care that your hands are not squeezed when you close the pump door.
•
Make sure that the infusion set is located in both sides of the tubing channel
notches after loading the infusion set.
4.3 Purge
NOTE
•
If required, set the purge rate after the purge is started. The initial purge rate
is 1200 ml/h.
•
The Air in Line or Accumulated Air alarm will not given during purging.
•
The volume used for purging is not added to the infused volume.
4.4 Starting Infusion
WARNING
•
Do not connect patient until disposables have been purged and loaded into
the pump. Connecting to patient before disposables are loaded and purged
can cause serious injury or death.
•
Check that no drops are falling in the drip chamber before infusion starts or
stops. If drips are falling, close the roller clamp or the Robert clamp, do not
use the equipment, and contact your service personnel.
NOTE
•
Always discharge the previous patient before starting a new infusion for new
patient. Failure to do so can lead to data being attributed to the wrong
patient.