Mindray BeneFusion uVP, Instructions For Use Manual

Page: 16 / 62

3 - 2
NOTE
•
Save the packing case and packaging material as they can be used if the
equipment must be reshipped.
•
This equipment is in accordance with the EN1789:2020 standard, and can be
used to transport patient through road ambulance.
3.2 Installation
CAUTION
•
To ensure that the pump operates properly, the drop sensor should be
properly installed when d/min is switched on.
•
To avoid mistakenly triggering the Empty alarm, adjust the rate to lower than
400ml/h when using the infusion set of 60 drops/ml.
•
After long time infusion, small drops may hang inside the drip chamber.
These small drops should be eliminated, Otherwise, they may affect the drop
detection accuracy and cause the Empty alarm.
NOTE
•
The liquid surface in the drip chamber should be lower than the lower edge
of the drop sensor, and lies between the one third and a half of the drip
chamber.
•
The positioning block of the drip chamber must be vertically inserted
through the positioning groove of the drop sensor.
•
Do not excessively tilt the drop sensor, or expose it to direct sunlight during
infusion. Otherwise, accuracy of the drop sensor may be influenced.
•
It is suggested that the signal line of drop sensor should be replaced every six
months.
3.3 Setting Up the Equipment
WARNING
•
Always use the accompanying power cord delivered with the pump.
•
Before connecting the equipment to the AC mains, check that the voltage
and frequency ratings of the power line are the same as those indicated on
the equipment.