MIMAKI JV22-130, Operation Manual

Page: 93 / 126

- 5.7 -
When medium thickness is changed [PRINT ADJUST]
When the head height is adjusted, make sure to correct the dot positions for the appropriate head
position is subtly different according to the head height. This function corrects the dot positions to
ensure that the accurate plotting result is obtained. Perform the function after adjusted the head
height.
The dot positions are corrected by comparing the ink dropping positions on each of the seven test
patterns between the two plotting directions.
• When in use of a roll medium, the back side of roll medium will loosen after
executing print adjust, for the medium returns to the plot original point.
STEP
1. Select the [PRINT ADJUST].
2. Push the [ENTER] key.
Plotting of the test patterns for the correction of dot position
starts. There are seven types of test patterns that are plotted.
3. Push the JOG keys [ ] and [ ] to correct the
dot position of pattern 1.
The seven test patterns that are output are sequentially
named [PATTERN 1] to [PATTERN 7].
Select the correct dot positions on [PATTERN 1] using the
JOG keys [ ] and [ ].
Select the dot positions that make a straight line on the test
pattern in the two plotting directions.
MAINTENANCE
PRINTadjust
< ent >
MAINTENANCE
PRINT START
: ent
MAINTENANCE
PATTERN 1
= 0. 0