MIMAKI JV22-130, Operation Manual

Page: 111 / 126

- 6.5 -
To prevent from cockring
Cockring may occur during printing. In case it occurs and head clashes wih the uneven surface of
media, perform the following procedure. Especially, when in use of transfer paper with transfer inks,
it may occur easily depending on the used transfer paper type.
Use a winding device
Refer to “Switching the direction of winding of the medium” for details.
Adjust the head height
Refer to “Adjusting the head height” for details.
Put a thin sheet to cover the holes on platen
This device equipeed with vacuum function that enables the media fit flatly onto platen. You can
confirm many holes (2mm in diameter) on the platen.
Depending on the media width, some media may not be able to cover all holes on the platen. (See
Figure.A) In the case, use the same kind of media or thin sheet to cover the holes, or the air may not
be able to vacuum completely from the holes.(See Figure.B)
Make sure to use a thin sheet (less than 1mm thickness) with no irregular
surface, or it may clash with the head.
We recommend you to use the black sheet to prevent a sensor glitch.
The best pitch for a sheet depth is between Feed roller( P 1.8) and the
Cutting line( P 1.9).
No media set
Media set
Thin sheet to cover
the holes on platen
Figure. A Figure. B
Media