MIMAKI JV22-130, Operation Manual

Page: 79 / 126

- 4.7 -
INK LAYERS
Sets the number of overwriting if ink coloring is poor.
(1-9 times)
DRYING TIME
This function sets an ink drying time. It sets the function for drying ink.
The drying time is the wait time by scanning and the time interval between the instant at which
the plotting operation is completed and the instant at which the medium plotted is cut off.
Specify the time to be established in accordance with the printing resolution on a drawing and
the type of medium to be used.
SCAN :
Sets the time of temporary stop at the capping station during the reciprocating motion of
the head.(0.0-9.9 sec)
• When 3 seconds or longer pause is specified, once the head is
capped, for the ink blockage protection function works.
AUTO CUT :
Sets the time between the end of plotting and medium cutting.
However, the AUTO CUT function needs to be enabled.(0-999 sec)
AUTO CUT
This function cuts off the medium automatically at the end of plotting.
If AUTO CUT is not specified, the device plots the next plotting data after plotting the current
data, without cutting off the medium.
(ON, OFF)
Even if AUTO CUT is not specified, you can cut off the medium by hand.
page 2.22
PRIORITY
Specifies whether the values set on the device (panel) are given priority or the values set on the
computer (host) are enabled as for the following seven functions.
(HOST, PLOT)
• MEDIA COMP.
• PRINT MODE
• INK LAYERS
• DRYING TIME
• AUTO CUT
• REFRESH
• VACCUM