Milwaukee AG 10-125, Original Instructions Manual

Page: 19 / 124

18
GB
EC-DECLARATION OF CONFORMITY
We declare under our sole responsibility that this product is in
conformity with the following standards or standardized documents.
EN 60745-1:2009
EN 60745-2-3:2011
EN 55014-1:2006 + A1:2009 + A2:2011
EN 55014-2:1997 + A1:2001 + A2:2008
EN 61000-3-2:2006 + A1:2009 + A2:2009
EN 61000-3-3:2008
in accordance with the regulations 2011/65/EU (RoHs), 2006/42/EC,
2004/108/EC
Rainer Kumpf
Director Product Development
Authorized to compile the technical file
Winnenden, 2012-09-06
MAINTENANCE
The ventilation slots of the machine must be kept clear at all times.
Do not let any metal parts enter the airing slots - danger of short
circuit!
Use only Milwaukee accessories and Milwaukee spare parts. Should
components need to be replaced which have not been described,
please contact one of our Milwaukee service agents (see our list of
guarantee/service addresses).
If needed, an exploded view of the tool can be ordered. Please state
the Article No. as well as the machine type printed on the label
and order the drawing at your local service agents or directly at:
Milwaukee Electric Tool, Max-Eyth-Straße 10, D-71364 Winnenden,
Germany.
ELECTRONICS
Electronic smooth start for save use prevents jerky run-up of the
machine.
A zero-voltage switch prevents the machine from restarting after a
power failure. On resuming work, switch the machine off and then
back on again.
The machine has an overload and anti-kickback safety function
and stops if it is overloaded. Please note that the machine will
automatically accelerate back to its original operating speed if the
load is removed from it. After it has reached its operating speed the
machine is ready for use again.
The built-in electronic will keep a constant speed even under
increased load. In case of overload, the rotational speed is being
reduced to standstill.
SYMBOLS
Please read the instructions carefully before starting
the machine.
CAUTION! WARNING! DANGER!
Always wear goggles when using the machine.
Always disconnect the plug from the socket before
carrying out any work on the machine.
Accessory - Not included in standard equipment,
available as an accessory.
Do not dispose of electric tools together with
household waste material! In observance of European
Directive 2002/96/EC on waste electrical and electronic
equipment and its implementation in accordance with
national law, electric tools that have reached the end
of their life must be collected separately and returned
to an environmentally compatible recycling facility.
Class II construction, tool in which protection against
electric shock does not rely on basic insulation only,
but in which additional safety precautions, such
as double insulation or reinforced insulation, are
provided.
English