Miller 907684001, Owner'S Manual

Page: 67 / 92

.
A complete Parts List is available at www.MillerWelds.com
OM-270536 Page 59
[ARC] [T/CY] Arc Timer: Monitors hours, minutes, and cycles of valid arc on. To view these different elements, rotate amperage adjustment
control. To reset, rotate amperage adjustment control until [RESET] [YES] is displayed. Press Menu button to display [RESET] [Done]. Dis-
plays turn to [000] [000].
[SLEP] Sleep Timer: Turns power off after the machine exceeds the programmed idle time without operation. Press the Standby button
to turn power on. To set or change time, rotate amperage adjustment control to desired time. Timer range: 1, 5, 10, 20, 30, 45 minutes or
one hour.
[STUC] Stick Stuck: Detects if the electrode is stuck or shorted to the workpiece. Turns weld output off to aid in freeing the electrode. To
turn on, rotate amperage adjustment control. Not recommended for air carbon arc or large diameter electrodes.
[MACH] [RESET] Machine Reset:: Resets all machine values back to factory defaults. To reset, turn amperage adjustment control to
[RESET] [YES]. Then press Amperage button. [RESET] [DONE] will be displayed when the reset is complete and factory defaults have
been restored.
[LOCK]: Limits user control and adjustability of machine. See Section 11-5 For instructions and operation.
[WELD] [TMRS] Weld Timers: [ON] enable and [OFF] disable the feature. See Section 11-3 for information on setting weld timers. Weld
Timers work with or without Sequencer feature.
[SOFT] [WARE] Software Number: Software number and revision will be displayed.
[OCV] Open Circuit Voltage: Allows user to select between Normal (NORM) and Low open circuit voltage. Low reduces open circuit voltage
to between 8 and 15 volts. To select, turn amperage adjustment control.
[EXPC] External Pulse Control Commands: Turn on when it is desired to control machine from an external source. When command is
on, a command voltage of 0 − 10 volts DC equals off − 210 amps.
[ERR] [LOG] Error Log: Use to view last eight logged error events. Each event may list multiple Error Codes. See Section 12-3.
[SERL] [NUM] Serial Number: If serial number displayed does not match serial number of machine, see Section 12-3.
[COOL] Cooler Auxiliary Power (Optional) : Selects between [OFF], [ON] (Non CE models Only), and [AUTO]. [OFF] disables the power
supply to the receptacle. [ON] enables the power to the receptacle. [AUTO] provides power to the receptacle when the TIG process is
active.