Migatronic RCI2, User Manual

Page: 40 / 80

40 41
Fieldbus Configuration file – PI and PI PLASMA - Full
All controls are available - 10010604
AnyBus Configuration – 10010604 v1.04
PI – Full Configuration
10010604.doc Page 2 of 3
INPUT BYTES to RCI
2
Byte# Bit# Name – Description – Example
25 – 26 193 – 208 Shield Gas Flow Rate
Set the SHIELD gas flow rate. [Litres/min*100]
Example: 6,0 Litres/min
Æ
600
27 – 28 209 – 224
Welding Time
Timer used to limit the duration of a welding spot, [1 unit = 10mSec]
Example: 0,4sec
Æ
40
29 225 – 232
Program number.
Select program #1 - #Max by value.
Maximum number depends from the machine in use.
By setting #0 the program can be selected directly on the Panel of machine or remote.
Example: Program no = #21
Æ
21
30 233 – 240 Fast pulsation mode
Possibility to enable the Fast Pulsation and select its characteristics
#0 = Fast Pulse Mode is Off
#1 = Fast pulse Mode is On
#4 = Fast pulse Mode is On – Synergic
(Pulse frequency depends from the level of current)
Example: Fast Pulse enabled
Æ
1 (most common Fast pulse mode used is #1)
31 241 – 248 Process selection
0 = Tig DC
1 = Tig AC
2 = MMA DC
3 = MMA AC
4 = Plasma DC
Example: Welding Process Plasma DC
Æ
4
32 – 33 249 – 264 Control Bits
Bit #249 – Quick-Stop (1 = stops the welding process)
Bit #250 – E-box Key Lock (1 = lock the box to prevent changes of parameters)
Bit #251 – Arc Start (trigger for Welding Arc)
Bit #252 – Start Pilot Arc (trigger for Pilot Arc).
Plasma gas must be purged manually prior to starting Pilot arc.
(Set Plasma gas value in byte 5&6, and purge Plasma gas Bit #256
Bit #253 – (not used)
Bit #254 – (not used)
Bit #255 – Shield Gas Purge
Bit #256 – Plasma Gas Purge
Bit #257 – Slow Pulse Enable
Bit #258 – LIFTIG
Bit #259 – Touch Sense
Bit #260 – (not used)
Bit #261 – (not used)
Bit #262 – (not used)
Bit #263 – (not used)
Bit #264 – Tack Welding Enable
34 265 – 272 Control Bits (Control of CWF)
Bit #265 – Wire Hold/Pause
Bit #266 – Wire Inch +
Bit #267 – Wire Inch -
Bit #268 – Disable Pulse Wire
Bit #269 – (not used)
Bit #270 – (not used)
Bit #271 – (not used)
Bit #272 – (not used)
35 273 – 280 Control Bits
Bit #273 – Reset Error – To clear pending errors on the machine, Cold wire feeder or interface
…
Bit #274 - #280 (not used)