Before using for the first time
35
Heating up the Dialog oven for
the first time and rinsing the
steam injection system
When the Dialog oven is heated up for
the first time it may give off a slight
smell. This can be eliminated by heating
the empty Dialog oven for at least an
hour. Use the Moisture Plus
function to rinse out the steam injection
system at the same time.
Ensure that the kitchen is well
ventilated while the appliance is
being heated up for the first time.
Prevent odours from escaping into
other rooms.
Remove any protective wrapping and
stickers (except the data plate) from
the Dialog oven and any accessories.
Before heating the oven up, wipe the
interior with a damp cloth to remove
any dust or bits of packaging that
may have accumulated during
storage and unpacking.
Insert all trays and the rack.
Switch the Dialog oven on with the
On/Off
sensor.
The main menu will appear.
Select
Oven functions
.
Select the Moisture Plus
function.
The recommended temperature will
appear (160 °C).
The oven heating and cooling fan will
switch on.
Set the maximum possible
temperature (250 °C).
Confirm with
OK
.
Select
Automatic burst of steam
.
The prompt to draw in water appears.
Fill a suitable container with the
required amount of fresh tap water.
Open the door.
Pull the water intake pipe forwards
(located below the control panel on
the left).
Immerse the end of the water intake
pipe in the container with tap water.
Confirm with
OK
.
The water intake process will begin.
The amount of water actually drawn up
into the oven may be less than the
amount specified as required, leaving a
small amount in the container.
Remove the water container after the
water intake process.
Confirm the message telling you that
the process is complete with
OK
.
