Miele Classic G 4205, Technical Information

Page: 92 / 159

Technical Information
92
G 5xxx
3 Fault Repair
3.1 Jammed Circulation Pump
Symptom:
With long intervals between wash cycles or at first commissioning (if the
period of time between manufacture and installation was long), the axial face
seal of the circulation pump can jam. As a result of this, the circulation pump
will not run (see
Fault Code F14 , Section 080-3.14).
Cause:
Axial face seal is jammed.
Remedy:
1. Remove the filter combination from the sump.
2. Pour in approximately one quart of hot water (no hotter than 167°F) with 3
to 5 drops of rinse aid and wait 5 minutes.
3. Restart the dishwasher.
Note:
The circulation pump must be replaced only if the above measures were not
successful.
3.2 Drain Pump Switches On and Off at Short Intervals
Symptom:
The drain pump operates with 1 second on and 4 seconds off.
Cause:
Electronic fault.
Remedy:
Replace the electronic. See Section 100-4.5 or 100-4.6.
3.3 Intake/Drain LED Flashes and Lights up Alternately (Incognito)
Cause:
On-site water supply valve closed.
Remedy:
Open water supply valve.
Cause:
Blockage in WPS (WaterProof System) filter.
Remedy:
1. Uninstall the appliance.
2. Disconnect the dishwasher from the power supply.
3. Lay the machine on its back.
4. Remove the drip pan. See Section 010-4.2.
5. Release the hose clamp securing the drain hose to the sump.
6. Open the plastic cover securing the WaterProof system mounting
assembly.
7. Unscrew the WaterProof system from its mounting assembly.