Miele Classic G 4205, Technical Information

Page: 70 / 159

Technical Information
70
G 5xxx
3. Remove the side panels. See Section 010-4.1.
4. Remove the drip pan. See Section 010-4.2.
5. Remove the connecting strip; see Section 030-4.5.
6. Release the cord from the spring.
7. Pull out the multi-plinth from the guide integrated in the rear panel.
Note:
Use caution when removing the left multi-plinth. The electrical connector to
the waterproof inlet valves is held in place. To remove, release the retaining
clips.
4.4 Steam Condenser Removal
1. Uninstall the appliance.
2. Disconnect the appliance from the power supply.
3. Remove the right side panel; see Section 010-4.1.
4. Open the door.
5. Remove the cutlery tray (if applicable).
6. Unscrew the splash protection cap (connection piece to air duct) from the
ceiling of the cabinet.
7. Remove the bottom basket.
8. Unscrew the vent from the right-hand wall of the cabinet.
9. Close the door.
10. Pull the top of the steam condenser assembly away from the cabinet.
11. Remove the air channel from the top of the steam condenser.
12. Using a small flathead screwdriver, unclip the retainers between the
condenser and fan; see Figure 040-6, Item 1. Remove the steam condenser
from the fan.
Note:
When re-installing, ensure that the retainers between the condenser and fan
engage properly.
4.5 Fan Removal
1. Uninstall the appliance.
2. Disconnect the appliance from the power supply.
3. Remove the right side panel; see Section 010-4.1.
4. Lay the machine on its back.
5. Remove the drip pan; see Section 010-4.2.
6. Remove the right multi-plinth; see Section 040-4.3.
7. Pull the seal off of the fan.
8. Disconnect all electrical connections from the fan.
9. Unclip the retainers with a small flathead screwdriver; see Figure 040-6,
Item 1.
10. Remove the fan from the steam condenser.