Miele Classic G 4205, Technical Information

Page: 103 / 159

Technical Information
103
G 5xxx
4. Remove the cover plate. See Section 030-4.4.
5. Disconnect the wiring harness from the drain pump.
6. Using a small flathead screwdriver, push the safety retainer clip outward
(Figure 050-20, Item 1).
7. Turn the pump clockwise and release it from its holder (Figure 050-20, Item 2).
Figure 050-20: Removing the Drain Pump
Note:
When installing, apply a little water or soap solution to the pump seal as a
lubricant. After installation, check all the pump fastening points.
Warning!
Installation aids that contain silicone, e.g., silicone grease, are not suitable
for use in dishwashers because of the damage they can cause.
If, e.g., hoses or seals are treated with silicone in order to facilitate
installation, this could jam the circulation pump. Furthermore, ingredients in
silicone grease can evaporate and damage electrical components such as
heater relays.
4.18 Removing the Float
1. Uninstall the appliance.
2. Disconnect the appliance from the power supply.
3. Remove the drip pan. See Section 010-4.2.
4. Pull the float off of the float switch.
Note: When re-attaching the float, make sure that the side with the mat. no.
faces downward (away from the float switch).
4.19 Removing the Float Switch
1. Uninstall the appliance.
2. Disconnect the appliance from the power supply.
3. Open the door.
4. Remove the bottom basket.
5. Remove the filter combination.