Miele Classic G 4205, Technical Information

Page: 111 / 159

Technical Information
111
G 5xxx
Figure 050-28: Replacing the WaterProof System Restrictor
11. Re-install the filter and the seal.
4.27 WaterProof System (WPS) Removal
1. Shut off the appliance and the water supply.
2. Uninstall the appliance.
3. Disconnect the appliance from the power supply.
4. Remove the left side panel (Section 010-4.1).
5. Remove the drip pan (Section 010-4.2).
6. Disconnect the hose from the water inlet valve.
7. Disconnect the electrical connection.
8. Unclip the wiring from the retainers. Release the WPS retainer from the
rear of the appliance and remove the WPS.
4.28 Filling the Salt Container in the Sump
1. Open the door, remove the lower basket and unscrew the salt container
lid.
Note: When opening the salt container, water will run out. Open the
container only to refill salt.
2. Before adding salt for the first time , fill the salt container with 2 quarts
(2 liters) of water.
Important:
The salt container must be filled with 2 quarts (2 liters) of water before
adding salt for the first time . Water does not have to be added with
subsequent refills.
3. Place the provided funnel over the salt container. Carefully fill with salt.
See Figure 050-29.The salt container holds approximately 4.5 pounds (2
kilograms) of salt. As it is filled, water will run out.
4. Clean any excess salt from the threads of the container opening. Screw
the lid on firmly.