Program settings
99
Altering a program
You can alter all parameters which are identified as changeable in the
program charts. Other settings can only be altered by Miele Service.
A program setting is altered in two steps:
- First the wash blocks must be reallocated to the program or the
existing allocation confirmed again. Only allocated program blocks
can be parameterized.
- Then the program parameters can be altered.
Document all changes of factory settings in case of a subsequent
Service call.
Changing program parameters on a validated machine will
necessitate a renewed performance validation.
...
Program settings
Change program
Change program
Universal
Standard
Select the program you want to alter.
For more information see “Allocating wash blocks”.
Allocating wash
blocks
For every program change the wash blocks must first be allocated.
Universal
Pre-rinse 1
Accept
Allocation is by multiple choice. A box is shown next to all wash
blocks in the display. If a wash block is allocated to the program,
there is a tick
in the box. This wash block is allocated to the
program by ticking the box or the allocation can be removed by
removing the tick.
The wash blocks can be selected or deselected using the
and
arrow buttons and confirming with
OK
.
To save the selection, select the
Accept
option at the end of the list
and confirm with
OK
.
If you want to adopt the preset wash blocks without any changes,
you can confirm the
Accept
option immediately with
OK
.
The further setting options will then follow. You can edit these in any
order you want.
