Problem solving guide
129
Problem
Possible cause and solution
Fault 578
The peak-load cut-out has lasted longer than 3 hours.
Have your electrical system and your energy
management system tested by a suitably qualified
person.
Process-related faults and messages
Problem
Possible cause and solution
Drying during program
deactivated
Drying cannot be selected at the start of a program
because drying is not available for the selected program.
Start the program without drying.
Or
Have the drying parameters for this program adjusted by
Miele Service.
Wrong code entered
The PIN code entered is not the same as the code saved.
Enter the PIN code again.
Report the loss of the PIN code to Miele Service.
Test program: Test object
can now be removed
This is not a fault.
A test program is running to check performance. At certain
points in the program the sequence is interrupted so that
samples can be taken.
Take a sample.
or
Wait. The program will continue automatically in approx.
30 seconds.
or
Continue the program without delay by pressing the
Start/Stop
button.
Program cancelled
This is not a fault.
A program which was running was cancelled by the user.
The wash cabinet interior can be very hot.
When the door is opened, hot steam and process
chemicals can escape. Protective measures for personal
safety must be observed.
Program continued
This is not a fault.
The process of cancelling a program was not completed.
The program which was running continued without
interruption.
Peak load cut-out
This is not a fault.
Individual components of the machine are paused while
there is a peak load signal from your energy management
system.
