Chapter 4: Using the Command Line Interface
156
After performing this command, the PDU prompts you to enter both current and new passwords respectively.
Important: After the password is changed successfully, the new password is effective immediately wether or not you type
the command “apply” to save the changes.
Example
This procedure changes your own password:
1.
Verify that you have entered the configuration mode. See
2.
Type the following command and press Enter.
config:#
password
3.
Type the existing password and press Enter when the following prompt appears.
Current password:
4.
Type the new password and press Enter when the following prompt appears.
Enter new password:
5.
Re-type the new password for confirmation and press Enter when the following prompt appears.
Re-type new password:
Setting Default Measurement Units
Default measurement units, including temperature, length, and pressure units, apply to the PDU user interfaces across all
users except for those whose preferred measurement units are set differently by themselves or the administrator. Diverse
measurement unit commands can be combined so that you can set all default measurement units at a time. To combine all
commands, see
Note: The measurement unit change only applies to the web interface and command line interface.
Tip: To change the preferred measurement units displayed in the PDU user interfaces for a specific user via CLI, see
Changing Measurement Units
(on page 95).
Set the default temperature unit:
config:#
user defaultpreferences preferredTemperatureUnit <option1>
