Chapter 4: Using the Command Line Interface
156
To query available parameters for the "show user" command:
#
show user ?
To query available network configuration parameters:
config:#
network ?
To query available role configuration parameters:
config:#
role ?
To query available parameters for the "role create" command:
config:#
role create ?
Showing Information
You can use the show commands to view current settings or the status of the PDU or part of it, such as the IP address,
networking mode, firmware version, states or readings of internal or external sensors, user profiles, and so on.
Some "show" commands have two formats: one with the parameter "details" and the other without. The difference is that
the command without the parameter "details" displays a shortened version of information while the other displays in-depth
information.
After typing a "show" command, press Enter to execute it.
Note: Depending on your login name, the # prompt may be replaced by the > prompt. See Different CLI Modes and
Prompts (on page 20).
Network Configuration
This command shows all network configuration and all network interfaces' information, such as the IP address, MAC
address, the Ethernet interface's duplex mode, and the wireless interface's status/settings.
#
show network
IP Configuration
This command shows the IP-related configuration only, such as IPv4 and IPv6 configuration, address(es), gateway, and
subnet mask.
Tip: To show IPv4-only and IPv6-only configuration data, see IPv4-Only or IPv6-Only Configuration (on page 23).
#
show network ip common
