Chapter 4: Using the Command Line Interface
156
Example 2 - Adding an IPv4 Firewall Rule
The following command adds a new IPv4 access control rule and specifies its location in the list.
config:#
security ipAccessControl ipv4 rule add 192.168.84.123/24 accept
insertAbove 5
Results:
•
A new IPv4 firewall control rule is added to accept all packets sent from the IPv4 address 192.168.84.123.
•
The newly added rule is inserted above the 5th rule. That is, the new rule becomes the 5th rule, and the original 5th
rule becomes the 6th rule.
Example 3 - User Blocking
The following command sets up two user blocking parameters.
config:#
security userBlocking maximumNumberOfFailedLogins 5 blockTime 30
Results:
•
The maximum number of failed logins is set to 5.
•
The user blocking time is set to 30 minutes.
Example 4 - Adding an IPv4 Role-based Access Control Rule
The following command creates a newIPv4 role-based access control rule and specifies its location in the list.
config:#
security roleBasedAccessControl ipv4 rule add 192.168.78.50 192.168.90.100
admin deny insertAbove 3
Results:
•
A new IPv4 role-based access control rule is added, dropping all packets from any IPv4 address between
192.168.78.50 and 192.168.90.100 when the user is a member of the role "admin."
•
The newly added IPv4 rule is inserted above the 3rd rule. That is, the new rule becomes the 3rd rule, and the original
3rd rule becomes the 4th rule.
Outlet Configuration Commands
An outlet configuration command begins with
outlet
. Such a command allows you to configure an individual outlet.
Changing the Outlet Name
This command names an outlet.
config:#
outlet <n> name "<name>"
