iSERIES Network Cameras ·
User Manual
With the function enabled, you don’t need to configure the port mapping for each
port, and the camera is connected to the Wide Area Network via the router.
Steps:
1.
Enter the UPnP™ settings interface.
Configuration >Advanced Configuration >
Network > UPnP
2.
Check the checkbox to enable the UPnP™ function.
The name of the device when detected online can be edited.
Figure 5-16
Configure UPnP Settings
5.3.10
Configuring Email Settings
The system can be configured to send an Email notification to all designated
receivers if an alarm event is detected, e.g., motion detection event, video loss,
video tampering, etc.
Before you start:
Please configure the DNS Server settings under
Basic Configuration >
Network >
TCP/IP
or
Advanced Configuration >
Network > TCP/IP
before using the Email
function.
Steps:
1.
Enter the
TCP/IP Settings
(
Configuration > Basic Configuration >
Network >
TCP/IP
or
Configuration > Advanced Configuration >
Network > TCP/IP)
to set
the IPv4 Address, IPv4 Subnet Mask, IPv4 Default Gateway and the Preferred
DNS Server.
Please refer to
Section 6.3.1 Configuring TCP/IP Settings
for details.
2.
Enter the Email Settings interface:
Configuration > Advanced Configuration > Network > Email
37
