Configuring Your Network Adapter for GigE Visionscape
GigE Net
w
ork
Configuration
A
Getting Started with Visionscape GigE Cameras
A-13
The inter-packet delay is the parameter that will allow us to control the
rate of data from the camera.
Let’s assume that we are using a CMG03c camera transmitting bayer
data. This camera is capable of running at 91 fps with an 8 millisecond
exposure time. With a 9000 byte packet size one frame of data (656 x 494
= 324,064 bytes + a small overhead) can be transmitted in 38 packets.
The actual data from the camera will be sent over the network at the clock
rate which, for gigabit Ethernet, is 125MHz. This is 8 nanoseconds per
clock. Assuming no overhead and no delays between packets our frame
of data from the CMG03c would take 324,064 clocks, which is 2.59
milliseconds. There is nothing we can do to change this time to transfer
the data.
With the InterPacketDelay (IPD) set to zero the camera sends one packet
of data and then immediately sends the next (actually there is a minimum
delay of approximately 96 nanoseconds). This process repeats until all
the packets that make up an image have been transmitted. Increasing the
IPD tells the camera to take a short break between sending each packet,
which might give other devices a chance to send some of their data.
We can put a delay between each packet. The inter-packet delay is set in
“ticks”, where there are 31,250,000 ticks in one second. From this we
know that 1 tick is 32 nanoseconds.
Let’s assume that we want our camera to run at 33 fps. In this case 1
frame is equal to 30.3 milliseconds. We can take off the fixed data
transmission time of 2.59 milliseconds and that leaves us 27.71
milliseconds. With 38 packets per image that means that every packet
needs to take 729 microseconds.
Dividing 729,000 nanoseconds by 32 nanoseconds gives us a tick count
of 22,781. This is the inter-packet delay we need to put in the Visionscape
registry entry.
The following calculations show how this works in reverse:
–
22,781 ticks is 729 microseconds.
–
A 2MB image is approximately 38 9k packets.
–
38 * 729 microseconds = 27.71 milliseconds.
