Chapter
3
Advanced Tool Tutorials
3-30
Getting Started with Visionscape GigE Cameras
Systems\Using Measurement Tools in an Inspection\. Select
clipgood1.tif and click Open. This will load the file and its path into
the File List.
Note:
This file was installed on your
hard drive when you installed Visionscape
®
. If you installed
Visionscape
®
to a location other than C:\Vscape, replace it with
the appropriate drive and directory designation.
7.
Right click Snapshot in the Step Tree (left pane) and select Insert Into
to display the Insert Step window. Click on the Analysis Tools tab.
Double click TwoPt Locator to add it to the Job. The TwoPt Locator
tool locates the tips of the two prongs on the part.
8.
Right click TwoPt Locator and select Insert Into to display the Insert
Step window. Double click Edge Tool to add it to the Job. The Edge
Tool locates edge points that will fit the circle shape on the part.
9.
Right click Edge Tool and select Insert Into. Click the Measurements
tab. Double click LeastSquaresCircle Fit to add it to the Job.
10.
Right click LeastSquaresCircle Fit and select Insert Into. Double click
Tolerance Meas to add it to the Job.
Rename Tolerance Meas to Circle Radius tolerance. To rename the
step, place the cursor on Tolerance Meas and right-click. This
displays the Step Context Menu. Select Rename and type Circle
Radius tolerance.
11.
Right click TwoPt Locator and select Insert Into. Click the
Measurements tab. Double click Dist2Pts Meas to add it to the Job.
Rename Dist2Pt Meas to Pin to Pin Distance. This will identify the
proper use of the tool to measure the distance between the tips of the
prongs.
12.
Right click Pin to Pin Distance and select Insert Into. Click the
Measurements tab. Double click Tolerance Meas to add it to the Job.
Rename Tolerance Meas to Pin to Pin Distance tolerance. This will
be used to tolerance the measured pin-to-pin distance.
13.
Right click TwoPt Locator and select Insert Into. Click the
Measurements tab. Double click Dist2Pts Meas to add it to the Job.