Chapter
3
Advanced Tool Tutorials
3-12
Getting Started with Visionscape GigE Cameras
This will run your Job once to verify your setup and settings. The
inspection should pass. This is indicated by a green check mark next
to the inspection.
Now is the time to add more images to the inspection. The images
text02.tif and text03.tif are good (pass). The image text06.tif is bad
(fail). This tutorial is designed to catch bad parts. This will enable you
to see the bad image that the inspection failed because it was outside
of the limits that were set.
32.
Maximize or open the Editor window by clicking
.
33.
Highlight Acquire in the Step Tree (left pane).
34.
Adjust the following setting:
–
File List — Click to the right of File List, and then click Add... This
displays the Open window. Browse for the files text03.tif and
text06.tif from Windows. They are located at: C:\Vscape\Tutorials
& Samples\Tutorials\GigE Systems\Defect Detection with Flaw
Tool\. Hold down the Ctrl key and select text03.tif and text06.tif
and click Open.
Note: These files were installed on your
hard drive when you installed Visionscape
®
. If you installed
Visionscape
®
to a location other than C:\Vscape, replace it with
the appropriate drive and directory designation.
35.
Minimize or close the Editor window.
36.
To run the program on the PC in a continuous loop, click
.
This will run a continuous loop of all the images and display a red
square next to the steps that fail.
You can also click
to run each image, one at a time, to view
results.
