Microscan NL-200, User Manual

Page: 51 / 51

NL-200 Series Controller User’s Manual
A
Addendum
Installation – see figure
• Remove either end cover by removing the four screws.
• The clips shown indicate the two orientations available for mounting.
• Select the orientation required, a pair of clips is used for each (AX or AY).
• Slide nuts (B) into the appropriate slots.
• Replace the end cover.
• Screws (C) are passed through mounting clips (A) and into slot nuts (B).
• Position the loose assemblies as required and tighten the screws.
DIN Rail Mounting Kit for NL Range
Pack Contents
Description Drawing Ref Quantity
Mounting Clip A 2
M3 Nut B 2
M3x8mm Countersunk screw C 2