Microscan NL-200, User Manual

Page: 36 / 51

11-2
NL-200 Series Controller User’s Manual
Command Configuration
(NL-220, NL-220F, NL-820F)
For example:
Parameter Meaning
0.1 0.1 milliseconds
200us 200 microseconds
0.1s 0.1 seconds
100ma 100mA
2.45A 2.45A
2.3 2300mA or 2.3A
The command codes and their meaning are described below. The upper case commands are shown,
followed by lower case letters denoting the numeric argument.
Error number Reason
Err 1 A parameter value is invalid
Err 2 Command not recognised
Err 3 Numeric value is wrong format
Err 4 Wrong number of parameters
Err 5 (This is only a warning) A timing parameter was
out of range and has been adjusted to a valid value.
Any changes made using Ethernet commands are not saved permanently until the AW command has
been issued.
11.2.1 General Commands
Report the version of firmware running in the NL220F
VR
This command returns the firmware version. For example:
NL-220F (HW001) V002
Set the rating of a light
This command sets the current or voltage rating for a light. If a current rating is being set,
then the voltage rating value should be 0.
VLo,v,c
Where:
o = output channel (1 or 2)
v = voltage rating (0 or 12 to 36)
c = current rating (0 or 10mA to 4A)