Microscan NL-200, User Manual

Page: 38 / 51

11-4
NL-200 Series Controller User’s Manual
Command Configuration
(NL-220, NL-220F, NL-820F)
Set the Trigger Input
This command sets which input is used for pulse and switch output modes.
RPc,p
Where:
c = output channel (1 or 2)
p = trigger input (1 or 2)
Set Internal Trigger
Enable or disable the internal trigger. When enabled, all outputs are triggered simultaneously using an
internal trigger signal. This setting can be saved to non-volatile memory using the AW command.
TT0 Disable internal trigger
TT1 Enable internal trigger (uses previously set period)
TT1,p Enable internal trigger and set the period
Where:
p= period of the triggers in microseconds
For example:
TT1,200 Set the internal trigger to 200ms (5Hz)
TT1,500US Set the internal trigger to 500us (2KHz)
Save the settings to memory.
AW
Once the settings are saved to memory they are then retained when the unit is switched
off. If this is not done, changes to the settings are volatile, and if the unit is switched off they
revert to those in force when the last AW command was issued.
Simulate an Input Trigger
TRc
c which input channel (1 or 2)
Simulates a trigger pulse. If the channel is in pulse mode it will pulse and show “PUL” on the
display.
Enable Ethernet Messages
GTm
m = 0 to disable Ethernet messages
= 1 to enable Ethernet messages
When Ethernet messages are enabled, any error reports are sent to the most recent UDP or
TCP address from which a command has been received.
Messages are of the form:
Ev tc,e
Where c zero for no channel or channel number (1 or 2)
v event value:
32 to 47 Lighting er or code
128 Light detected and waiting for current rating
129 Light detected and not waiting for current rating