Handling of Consumables 27
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX
Operator’s Manual SOLID T11 DT / TT
Edition 1.1
7.
Loosen the two thumbscrews at the rear side of the printer
(near the paper input opening; see the following figure).
8.
Adjust the material guides (label width guides) to the new
media with.
Please note: The guides are interlocked to maintain a center
justified label path.
Fig. 5.2.1.d Loosen the two thumbscrews to adjust the label width guides
9.
Tighten the two thumbscrews.
10.
Check to make sure the green “Media loaded” LED on the
back panel is off (if not go back to step 5, if need be).
11.
Thread the media into the back of the printer between the
material guides (label width guides). As soon as it is correctly
positioned, the green “Media loaded” LED will be on.
Label width
guides
Thumbscrews
(Media width
adjustment)