124 Troubleshooting
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX
Operator’s Manual SOLID T11 DT / TT
Edition 1.1
9.3. Incorrect Media Transport
Defect
Remedies
Incorrect media transport
(no gap detection between
labels e.g.)
- perform the basic operations
(see chapter 4)
- check if the Sync Sensor has been adjusted
correctly (see section 7.26 up to 7.28)
- check if the media has been loaded
correctly
(compare section 5.2)
- check if the ribbon has been loaded
correctly (SOLID T11 TT)
(compare section 5.3)
- clean the transport rollers
(see section 8.1.3)
No straight transport of the
consumables
(torsion or folding of the
ribbon, e.g.)
- check if the ribbon has been loaded
correctly (SOLID T11 TT)
(compare section 5.3)
- check if the media has been loaded
correctly
(compare section 5.2)
- clean the transport rollers
(see section 8.1.3)
Paper Jam
in addition to the remedies above:
- release the printhead to remove the paper
(compare chapter 5)
- check if the jammed consumables have
been removed completely.
If the remedies above are not successful, please call a MICROPLEX
authorized
service
engineer.
