Microplex SOLID F166 HD, Operator'S Manual

Page: 85 / 92

SOLID F166 HD User Manual
5-7
Code Descriptions Check Point Countermeasure
13
Paper remaining in paper
output section (POPS) Paper is remaining in the paper
output section (at POPS position). Remove the remaining paper.
Paper is not remaining in the
paper output section (at POPS
position). Call service engineer.
16
Abnormal paper position Tractor position is not properly
set (paper is too tight or too
loose).
Set the tractor position
properly.
Paper position is not correctly set. Set the paper position
correctly.
Paper position is set correctly. Call service engineer.
17
High voltage failure Main charger, pre-charger,
transfer charger, or developing
unit is not properly set. Set the main charger,
pre-charger, transfer charger,
or developing unit properly.
Main charger, pre-charger,
transfer charger, or developing
unit is properly set. Call service engineer.
18
Drum motor failure
(Abnormal rotation speed) OPC drum is not properly set. Set the OPC drum properly.
Turn the POWER switch ON. The
drum motor does not operate at
the proper timing during the
power-on initialization process or
is not normal (rotation speed is
not stable). Replace the cleaning unit.
If the error is still not cleared,
call service engineer.
Turn the POWER switch ON. The
drum motor operates at the proper
timing during the power-on
initialization process and is
normal (rotation speed is stable). Call service engineer.
19
Surface potential too high Reinstall the main charger.
If the error is still not cleared,
call service engineer.
1A
Surface potential too low Main charger is not properly set. Set the main charger properly.
Main charger wire is dirty. Clean the main charger wire.
If the error is still not cleared,
call service engineer.
1B
No Pre-Charger
Pre-charger is not set. Set the pre-charger.
Pre-charger is set. Call service engineer.
1E
Flash power supply failure Fuser unit is not properly set.
Set the fuser unit properly.
Flash power supply is overheated. Let the flash power supply
cool for a while with the
power on.
Fuser unit is set properly. Call service engineer.