Microplex SOLID F166 HD, Operator'S Manual

Page: 86 / 92

SOLID F166 HD User Manual
5-8
Code Descriptions Check Point Countermeasure
1F
Flash failure Flash power supply AC IN
voltage is normal. Check AC power source.
Flash power supply AC IN
voltage is not normal. Call service engineer.
20
Fuser unit overheat Fuser unit is not properly set. Set the fuser unit properly.
Fuser unit exit blower is stopped
or the rotation speed of the
blower is too low. Call service engineer.
Fuser unit cooling fan is stopped. Call service engineer.
22
Developing motor failure
(Abnormal rotation speed) Turn the POWER switch ON. The
developing motor does not
operate or is not normal at the
proper timing during the
power-on initialization process. Call service engineer.
23
Developing unit set
incorrectly The developing unit is not
properly set. Set the developing unit
properly.
The developing unit is properly
set. Call service engineer.
24
Cleaner unit set
incorrectly The green lock lever of the
cleaning unit is set at the “OPEN”
position. Turn the green lock lever of
the cleaning unit to the
“LOCK” position.
The green lock lever of the
cleaning unit is set at the
“LOCK” position. Call service engineer.
25
No Transfer-Charger
Transfer charger is not set. Set the transfer charger.
Transfer charger is set. Call service engineer.
26
No cleaning unit
Cleaning unit is not set. Set the cleaning unit.
Cleaning unit is set. Call service engineer.
28
Waste toner box full Waste toner in the waste toner
box reaches the full level. Replace the waste toner box.
Waste toner in the waste toner
box does not reach the full level. Clean the waste toner full
sensor.
If the error is still not cleared,
call service engineer.
29
No waste toner box Waste toner box is not set. Set the waste toner box.
Waste toner box is set. Call service engineer.
2A
No toner An oscillation sound is emitted by
the toner empty sensor when there
is not enough toner in the
developing unit. Replace with a new toner
cartridge.
There is enough toner in the
developing unit. Call service engineer.
2C
Toner density too low There is enough toner in the
developing unit. Call service engineer.