Microplex SOLID F166 HD, Operator'S Manual

Page: 87 / 92

SOLID F166 HD User Manual
5-9
Code Descriptions Check Point Countermeasure
32
LED array overheat
Fuser exit blower or fuser unit
cooling fan is stopped.
Call service engineer.
The rear cover side of the printer
is too close to the wall.
Make enough space between
the rear cover side of the
printer and the wall.
If the error is still not cleared,
call service engineer.
33
Rear cover open
Rear cover is removed. Install the rear cover.
Rear cover is installed. Call service engineer.
38
Memory fail
Call service engineer.
39 High Voltage Failure -
+HV1 Main Charge
Main charger is not properly set. Set the main charger properly.
Main charger is not normal. Replace the main charger.
If the error is still not cleared,
call service engineer.
3A High Voltage Failure -
+HV2 Pre-Charge
Pre-charger is not properly set. Set the pre-charger properly.
Pre-charger is not normal. Replace the pre-charger.
If the error is still not cleared,
call service engineer.
3B High Voltage Failure -
-HV Transfer Charge
Transfer charger is not properly
set.
Set the transfer charger
properly.
Transfer charger is not normal. Replace thetransfer charger.
If the error is still not cleared,
call service engineer.
3C High Voltage Failure -
+HV3 Separation Charge
Separation charger is not properly
set.
Set the separation charger
properly.
Separation charger is not normal. Replace separation charger.
If the error is still not cleared,
call service engineer.
3D High Voltage Failure -
+DRL Developing Bias
Developing unit is not normal. Replace the developing unit.
Developing unit is normal. Call service engineer.
3E High Voltage Failure -
-V1, -V2 Cleaning Bias
Call service engineer.