c.
Suppress Output Until First Sync
Choose whether the DCF-77 output will be suppressed until the GridTime 3000 has synchronized to
its first time source on startup. The 'SUPPRESS OUTPUT UNTIL FIRST SYNC' radio buttons is set to
'DON'T SUPPRESS' by default.
d.
Suppression Occurs
Choose whether the output signal will get locked into a high or low (on the Fiber port these will be
displayed as illuminated or dark and for the HV MOSFET open or closed) state during suppression. The
'SUPPRESSION OCCURS' radio buttons are set to 'GO TO LOW STATE' by default.
7.
Save Settings
Click the 'SAVE' button to write the settings to the GridTime 3000.
A 'Saved!' notification will appear in the bottom right corner of the page indicating that the settings have
successfully been written to the GridTime 3000.
9.8.1.4
Programmable Pulse Output
This section describes how to provision a GridTime 3000 pulse port to output custom pulses.
Note:
The programmable pulse output provisioning process is the same for all BNC ports, the ST Fiber outputs, and
the HV MOSFET port. The screenshots in this section will use Port 3 — a Frequency/DCLS BNC port as an example.
1.
Navigate to Port's Window
Navigate to the window for the port you want to configure by clicking on the port's corresponding icon, then
clicking the settings bar corresponding to the port.
Provisioning
©
2022 Microchip Technology Inc.
and its subsidiaries
Manual
DS00004572A-page 171
