2.
Enable Port
Select 'ENABLE SIGNAL (LOW IMPEDANCE)' from the 'HIGH IMPEDANCE OUTPUT' radio buttons. This will
reveal the E1 output specific settings.
3.
Select Framing Format
Select the appropriate 'FRAMING FORMAT' option from the 'FRAMING FORMAT' dropdown. By default the
'FRAMING FORMAT' is set to none.
4.
Select Waveform Shaper
Select the waveform shaper from the 'WAVEFORM SHAPER' dropdown. By default, the 'WAVEFORM
SHAPER' is set to 120 ohm External
5.
Select Encoding Type
Select the applicable encoding type from the 'ENCODING TYPE' dropdown. Select the encoding type from the
'ENCODING TYPE' dropdown. By default, the 'ENCODING TYPE' is set to High Density Bipolar Order 3.
6.
Select Transmitter Impedance Matching
Select the correct transmitter impedance matching from the 'TRANSMITTER IMPEDANCE MATCHING'
dropdown. By default, the 'TRANSMITTER IMPEDANCE MATCHING' is set to 110ohm.
Provisioning
©
2022 Microchip Technology Inc.
and its subsidiaries
Manual
DS00004572A-page 159
