Micom Autodoor EDM NII Series, Operation Manual, Page: 22 / 23

Open B (Output) OB
Break relay contact at full open position. OE SIGNAL RELAY
B
Close A (Output) CA
Make relay contact at full closed position. CE SIGNAL RELAY
B
Close B (Output) CB
Break relay contact at full closed position. CE SIGNAL RELAY
B
Refer to the standard wiring diagrams for further information.
6-3 Signal layout on the extension boards.
Output board [OUT] Input Output board [I/O]
0 1 2 3 4 5 6 7 Board address
OPN WA SBO LOB PBO PS PS
CLS ERR UL LCB PBC RS RS
STP OE - LHO PBS HRS HS
HOP CE - LCS PBH OSE ES
SPC IL NT AS
EO PR RS1 RS1
OE OE OE OE
CE CE CE CE
6-4 Corresponding table between Board address and DIP switch
Output board [OUT] Input Output board [I/O]
Board address 0 1 2 3 4 5 6 7
DIP switch1 OFF ON OFF ON OFF ON OFF ON
DIP switch2 OFF OFF ON ON OFF OFF ON ON
Default Default
Note: Above chart is printed on the each extension board, such as shown below.
DIP Switch is on the expansion board. (To change the setting, remove lid)
OFF
ON
0 1 2 3
OUT
1
2
ADDRESS
DIPSW
OFF
OFF
ON
ON
ON
OFF
O
F
F
LED (Red)
OFF
ON
4 5 6 7
I/O
1
2
ADDRESS
DIPSW
OFF
OFF
ON
ON
ON
OFF
LED(Green)
O
F
F
7. Adjustment of sensor
Refer to a sensor instruction manual for wiring and adjusting sensor.