EDM NII Series
Control Manual
IMPORTANT NOTICE
Please read these instructions carefully before installing the door operator. We are not
responsible for any loss or damage if these precautions are not followed. The device must be
installed correctly according to the installation and wiring instructions.
During maintenance and installation, the power should be turned OFF.
Please use the correct power supply. Control box accepts 100VAC only.
(Do not connect 220-240VAC directly)
Make sure that the operator is grounded or connected to earth! The coating of the operator is
made of an electrically conductive metallic material, which will easily induce electrical conduction!
Make sure the ground or earth wire is connected!
The operator housing is not completely sealed, therefore it should be noted that excessive
moisture or a corrosive atmosphere could destroy the electronic components contained within.
Do not attempt to modify, repair, or alter any parts within the control box. Do not remove screws
and bolts from the internal structure of the Control Unit. The failure to comply will result in loss of
warranty.
Installation and maintenance of this product can be performed by MICOM authorized technician or
personnel only.
Before switching ON the power supply, make sure that no objects obstruct the travel of the
automatic doors.
Ensure door travel area is clear before switching power switch ON. Failure to comply may cause
incorrect operation.
Do not switch off power supply whilst door(s) is in motion. Failure to comply could result in death
or serious injury.
Take special care of finger entrapment when used as manual slide door with mains power off.
Failure to comply may cause a finger trap hazard.
Operation speeds should comply to relevant standards
Do not obstruct door movement. This could result in stalling the door operation, due to our
overload protection feature. To re-start, power Off / On is necessary.
Follow all indicated instructions, as improper installation could cause severe damage.
Please keep these instructions.