Operating Instructions Synchroprint 5000
Operating instructions SP5000 V1-0.docx
Page 46 of 52
9.9.2.
Error messages tablet
If an error is recognized by the control unit a message will be displayed on the tablet. Beside an
error message you get an error description and an error number. After the error reason is eliminated
the message must be cleared. An emergency shutdown must be confirmed first with the “error-
reset-button” on the backside of the control panel and afterwards with the “Confirm-Button” on the
tablet. Other messages must be confirmed two times on the tablet.
10.
Trouble shooting
10.1.
Basic errors (without error message)
Error description
Possible reason
Fault clearance
Control panel does
not boot up
Main power switch
switched off.
Switch on main power switch!
Power supply of machine is
missing.
Is frequency converter display active? YES:
Power supply existent. NO: Reestablish
power supply!
No 24V power supply at
control panel.
Are the station displays on? YES: Power
supply existent. NO: Fuse or ON/OFF relay
defective.
Terminal unit not
connected to the Servo-
PCB.
Check wiring from the terminal unit to the
Servo-PCB panel (see wiring diagram)!
Before trying to locate any fault, it must be made sure that the machine may
not move unintentionally. Before entering the danger zones, one of the
machine’s safety facilities/devices must be actuated; in case of required work
on current-carrying parts, the machine must be cut off from the supply voltage
(using the main power switch).
Error number
Error message
Error
description
Confirm-Button
