M3
Page 69
10.
CONFIGURATION OF THE UNIT WITH QR CODES
The M3 displays offers the possibility to be configured by a simple scan of QR code.
You should use the QR Code reader Metro reference ACS-AFF-003.
This will simplify the configuration and reduce risks of errors. It takes less than 2
seconds to configure the display with a QR code scan.
List of commands :
All the RS232 commands listed on the table chapter 8 - RS232 communication can
be encoded on a QR code.
The goal of the configuration by QR code is generally to save time and limit
configuration errors when the display is used for several configuration.
Before sending a new configuration to the display, it is recommended to start sending
a reset command, so that all the previous parameters will be reset the default;
because the QR code we only modify the encoded parameters. Other parameters will
remain the same.
This command is : RST
After sending this command, you must start the configuration by the general
parameters, then configuration of the characteristics,
Summary of Contents for M3
Page 31: ...M3 Page 31 Grey color because of the class parameters ...
Page 41: ...M3 Page 41 MB 8I Module Inductif MB 4D Module Port Mitutoyo MB 1R Module Port RS232 ...
Page 45: ...M3 Page 45 Air gage MB AG module Must be calibrated ...
Page 46: ...M3 Page 46 7 98 8 02 Write here the 2 calibration value which will be used ...
