Metro DataVac M3, User Manual

Page: 44 / 88

M3
Page 44

Clear : (Input) reset the 0 mode (come back to absolute mode)

Init dyn : (Input) start a dynamic measure

Characteristic status : (output) output a signal if the characteristics are ok

Ctrl limit - : (output) output a signal if the part is in the lower control limit

Ctrl limit + : (output) output a signal if the part is in the upper control limit

- No Go : (output) output a signal if the part is out of the lower tolerance limit

+ No Go : (output) output a signal if the part is out of the upper tolerance limit

Part status: (output) output a signal if the whole part (the 2 probes) respects
the tolerance limit.

Class : (output) output a signal if the part is in the selected class

Hold: (Input) freeze the screen to display the previous measure as long as the
input signal stay.

Characteristic : (output) changes the displayed screen in the measuring screen

Touchscreen : disconnect the touch screen function. Useful when connected to
a PLC, so that no one can use the touch screen without the permission of the
PLC.
5.3.6. Air gage MB-AG module
The following information are focused on air gage modules and probes.
After being connected and linked to a channel thanks to the MBus menu (channel 1 in
the example bellow), the probe must be parametrized. To make it, the corresponding
channel screen must be check.
The air gage’s probe menu needs a calibration before doing the measurement.