M3
Page 36
5.3.1. Generalities
The following screen is displayed whatever your probe is. The different options are:
In addition to this general information, some more options are displayed and
depends on the concerned probe.
Allows to know the
electrical position of the
probe in order to adjust it
on its fixture.
It is recommended to
adjust the inductive
probes close to their
« electrical zero »
Chanel 1 or 2. Each channel
can display different
information
Possibility to
connect an M-Bus
Allows to slow
down the refresh
frequency of the
display
(running
average)
. It can
be useful to limit
the blinking of the
last digit, and for
runout
measurement on
large parts.
The unit of
measurement
is always
displayed
here, but it
can change
depending on
the probe.
Summary of Contents for M3
Page 31: ...M3 Page 31 Grey color because of the class parameters ...
Page 41: ...M3 Page 41 MB 8I Module Inductif MB 4D Module Port Mitutoyo MB 1R Module Port RS232 ...
Page 45: ...M3 Page 45 Air gage MB AG module Must be calibrated ...
Page 46: ...M3 Page 46 7 98 8 02 Write here the 2 calibration value which will be used ...
