MI 3205 TeraOhm XA 5kV
Measurements
41
5.6.1 Set Limit
With the high limit the user is allowed to set the limit resistance value. Measured
resistance is compared against the limit. Result is validated only if it is within the given
limit. Limit indication is shown by the bar Bar – graph marker (see Figure 5.10).
Figure 5.11:Limits marker
Message window:
Measurement result is within defined limit.
Measurement result is out of defined limit.
Note:
Pass / Fail indication is only displayed if limit is set and if no Break down, Over
voltage or Noise is detected during measurement.
