Care and maintenance
| EN
27
3
Pull down the centrifuge support and detach the centrifuge cover from the centrifuge (do not remove
the centrifuge inlet seal!)
4
Swing out the centrifuge.
5
Pull off the centrifuge flange cap (1).
1
2
3
Loosen the 4 fastening screws on the centrifuge flange (2) and remove the flange.
Remove both centrifuge inner parts (3) upwards.
Separate the inner and outer centrifuge chambers.
Hold each centrifuge chamber individually against a light source and visually check for contamination;
especially make sure that the transfer openings at the bottom of the chambers are free.
Centrifuge chambers that exhibit heavy soiling, deposits or accumulations of solids must be replaced!
If necessary, the complete centrifuge must be replaced.
6
Reassemble the centrifuge in reverse order (note the alignment pin and hole of the centrifuge
chambers!)
7
Carry out a normal operation test
see 7.2.3. Normal operation test
7.2.6. Replacement of module 2
1
Prepare new module 2 (without collection container).
2
Tilt the locking bracket on module 2 upwards, remove it and place it on a flat, non-slip surface.
3
Open the 4 yellow clip fasteners on module 2.
4
Hold the collection container and lift off the upper part.
5
Place a new module 2 (without collection container) on the collection container.
Pay attention to the FRONT marking on the collection container!
6
Close the 4 yellow clip fasteners on module 2.
Clean the sealing rings on the left and right in the supporting element with a damp paper towel and grease them with multi-silicone grease (or Vaseline).
7
Carefully push module 2 back into the holder and close the locking bracket.
7.2.7. Replacement of module 3
See 7.2.5.1. Visual check of the centrifuge.
7.2.8. Replacement of the magnetic valve
1
Tilt the locking bracket on module 2 upwards, remove it and place it on a flat, non-slip surface.
