Metapace T-2, Command Manual

Page: 17 / 54

Rev. 1.00
- 17 -
Metapace T-2
ESC a n
[Name]
[Format]
[Range]
[Default]
[Description]
Select justification.
ASCII ESC a n
Hex 1B 61 n
Decimal 27 97 n
0 ≤ n ≤ 2, 48 ≤ n ≤ 50
n=0
▪ In standard mode, aligns all the data in one line to the position specified
by n as follows :
n Justification
0, 48 Left justification
1, 49 Centering
2, 50 Right justification
ESC c 3 n
[Name]
[Format]
[Range]
[Default]
[Description]
Select paper sensor(s) to output paper end signals.
ASCII ESC c 3 n
Hex 1B 63 33 n
Decimal 27 99 51 n
0 ≤ n ≤ 255
n=0
▪ Selects the paper sensor(s) to output paper end signals when a paper
end is detected.
Bit Off/On Hex Decimal Function
Off 00 0 Paper roll near-end sensor disable. 0
On 01 1 Paper roll near-end sensor enable.
Off 00 0 Paper roll near-end sensor disable. 1
On 02 2 Paper roll near-end sensor enable.
Off 00 0 Paper roll end sensor disable. 2
On 04 4 Paper roll end sensor enable.
Off 00 0 Paper roll end sensor disable. 3
On 08 8 Paper roll end sensor enable.
4~7 - - - Reserved.
[Note]
▪ This command is available only with a parallel interface and is ignored
with a serial interface.
ESC c 4 n
[Name]
[Format]
[Range]
[Default]
[Description]
Select paper sensor(s) to stop printing.
ASCII ESC c 4 n
Hex 1B 63 34 n
Decimal 27 99 52 n
0 ≤ n ≤ 255
n=0
▪ Selects the paper sensor(s) to use to stop printing when a paper end is
detected.